Skip to main content

Your Cart

Your cart is currently empty.
Click here to continue shopping.
Department of Skate ships Internationally!

Kingpin - Roll Line 13mm Click-Action Standard

  • Description
  • Description
  • Roll-Line 13mm Click-Action King Pin Standard

         for Frames with “04” (each)

    for use in Click Skate Frames “04”:

    Mariner Cup
    Mistral
    Energy Steel
    Energy Titanium
    Dance
    Rafaello
    Ring
    Saturno
    Giotto
    Spin 

    Roll-Line 13mm Click-Action King Pins are engineered to be light-weight and withstand the use and abuse of high level competitive Skating.

    Roll-Line 13mm Click-Action King Pins have a 13mm deep socket and thread that screw into a Roll-Line Skate Plate (labeled “04”, which means the Skates were manufactured after 2004).  When installing, a 16mm, two (2) sided flat wrench will be required, or better yet and the easiest way to change King Pins, use the special custom King Pin Removal Tool.  The King Pin Removal Tool is usually mounted into a bench mounted vice or used with a large Breaker Bar.  Without the King Pin Removal Tool it is extremely difficult to remove the King Pin without damaging or destroying the wrench flats, as the King Pins are installed with BLUE Removable Loctite to ensure they stay locked into the Skate Plate.  When installing new King Pins ALWAYS use the BLUE Removable Loctite.

    Roll-Line 13mm Click-Action King Pins are engineered to bend before breaking, so they rarely break. Normal causes for King Pins to need to be replaced are:

    1.  Improperly Adjusted Pivot Pins (see Pivot Pins for more information on properly adjusting) which move up and down or side to side in the socket, allowing an extra ordinary amount of stress and strain on the King Pins.

    2.  The Adjusting Threads on the bottom of the King Pin get Stripped.  This usually only happens when the King Pin Locking Keeper Screw is loosened and the Adjusting Click Nut is run on the very last thread or two.  (see Suspension Cushion information to ensure you are using the correct hardness Suspensions for your application.)